?
Using Portraits of N-Norms for Large-Scale Investigation of Circuits with Modal Reservation
P. 1–4.
R. R. Gazizov, Medvedev A. V., Gazizov T. R.
The study proposes to improve the process of large-scale investigation of circuits with modal reservation demonstrated on the example of double-sided printed-circuit board (PCB) with polygons. The TALGAT software was used as a simulation environment. The five different portraits (values along the conductor) of N-norms were obtained for each of the three signals: trapezoidal ultrashort pulse, real ultrashort pulse, and electrostatic discharge. The maximum and minimum values of N-norms are given. The features of dependencies behavior were identified. The analysis of simulation results revealed a large number of increases in the values of N-norms along the conductor relative to the input. To perform quick formalized assessment of signal propagation peculiarities in the circuits under study, we propose to use the portraits of N-norms. This work is part of the large-scale investigation of circuits with modal reservation.
Ramenskaya A., Бектемиров Р. Р., Корнейченко Е. Н., В кн.: Имитационное моделирование. Теория и практика (ИММОД 2025).: СПб.: АО "ЦТСС", 2025. С. 463–470.
Banks need to analyze the preferences and behavior of their customers for stability. The high value of the key rate has affected the deposit policy of banks. The purpose of the study is to develop simulation model of customer behavior in the regional bank deposit market. The paper proposes an agent-based simulation model describing the ...
Added: April 20, 2026
Sultanov R., Safin R., Martinez-Garcia E. et al., , in: Proceedings of the 21st International Conference on Informatics in Control, Automation and Robotics - (Volume 1) ICINCO 2024.: SciTePress, 2024. P. 519–526.
Vision is one of the well-researched sensing abilities of robots. However, applying vision-based algorithms can be challenging when used in different environmental conditions. One such challenge in vision-based localization is dynamic lighting conditions. In this paper, we present a new Gazebo plugin that enables realistic illumination changes depending on a current Sun's position. A plugin's ...
Added: March 17, 2026
Gamberov T., Safin R., Tsoy T. et al., , in: Proceedings of the Fifth International Conference on Agriculture Digitalization and Organic Production (ADOP 2025), Volume 1. Robotics in Agriculture. (SIST, volume 453).: Springer, 2026. P. 175–187.
The agricultural sector is undergoing a digital transformation due to modern automation, robotics, sensing, and simulation technologies. This research explores a use of digital human models (DHMs) in the Gazebo virtual environment to enhance agricultural workflows, improve human-robot interaction, and ensure safety. We propose a framework that models typical agricultural scenarios, such as field mapping, ...
Added: March 17, 2026
Stepanyants V., , in: 2025 International Russian Automation Conference (RusAutoCon).: IEEE, 2025. P. 982–986.
Transportation systems are complicated and deal with significant problems. With the pool of possible solutions being wide, extensive transportation planning has to be involved. However, planning based on expert opinions is significantly limited in terms of rapidity, accuracy, and confidence. Computer-aided design and automated decision-making systems are the next step to ensure transportation system development ...
Added: October 3, 2025
Zanko Georgii, MULTIDISCIPLINARY SCIENCE JOURNAL 2025 Vol. 8 No. 1 P. e2026126
Effective cash management remains a persistent challenge in dynamic economic landscapes, particularly under VUCA conditions. While traditional cash management models, including stochastic programming, have offered valuable insights, their limitations in capturing rapid changes and unknown uncertainties are becoming increasingly apparent. This paper addresses this gap by conducting a comparative analysis between a Stochastic Goal Programming ...
Added: September 12, 2025
Ivanov D., Rozhkov M., , in: Handbook of Ripple Effects in the Supply Chain.: Springer, 2025. Ch. 11 P. 215–247.
We study capacity disruption and recovery policy impacts on supply chain (SC) performance. Discrete event simulation methodology is used for analysis with real company data and real disruptions. Two novel findings are shown. First, disruption-driven changes in SC behaviour may result in backlog and delayed orders, the accumulation of which in the post-disruption period we ...
Added: May 15, 2025
Anna Volodkevich, Ivanova V., Vasilev A. et al., , in: Advances in Information Retrieval: 47th European Conference on Information Retrieval, ECIR 2025, Lucca, Italy, April 6–10, 2025, Proceedings, Part IV.: Springer, 2025. P. 425–430.
Simulators for recommender systems are widely used for recommender systems performance evaluation and feedback loop effects analysis. Existing simulators often propose inflexible pipelines, are focused on narrow research tasks, or are not adapted to work with industrial large data volumes. To address these challenges, we developed the Sim4Rec simulation framework. The Sim4Rec models key aspects ...
Added: April 10, 2025
Rozhkov M., Alyamovskaya N., Zakhodiakin G., International Journal of Production Research 2025 Vol. 63 No. 18 P. 6630–6647
This article investigates the application of reinforcement learning (RL) methods to optimise a four-echelon linear supply chain model with stochastic demand. The proposed supply chain configuration is largely based on the production-distribution supply chain of the MIT Supply Chain Beer Game. We show that RL can significantly improve ordering efficiency and overall supply chain performance. ...
Added: March 24, 2025
Sulaiman S., Eryomin A., Pillai A. et al., , in: 2024 4th International Conference on Computer, Control and Robotics (ICCCR).: IEEE, 2024. P. 300–304.
Manipulators are used extensively in industrial and service sectors due to their capability to carry out a task effectively. This paper presents a kinematic modelling, a workspace analysis, a static structural analysis and a simulation study of a simple 3 degrees-of-freedom (DoF) Cartesian manipulator developed for pressing buttons of an elevator. Denavit-Hartenberg approach was used ...
Added: February 19, 2025
Sulaiman S., Eryomin A., Tsoy T. et al., , in: 2024 IEEE 7th Eurasian Conference on Educational Innovation (ECEI).: IEEE, 2024. P. 410–413.
Intelligent robots are employed in a wide variety of sectors due to their capability to carry out a task autonomously. As a response for a growing importance of intelligent robots, a new master program in intelligent robotics was introduced by Kazan Federal University, Russia in 2017. It was created by analysing curricula of top robotics ...
Added: February 19, 2025
Мустафина Н. И., Plaksin M. A., В кн.: BIG DATA и анализ высокого уровня = BIG DATA and Advanced Analytics : сборник научных статей X Международной научно-практической конференции в двух частях, Часть 1 (Республика Беларусь, Минск, 13 марта 2024 года).: Мн.: БГУИР, 2024. С. 457–469.
Added: February 18, 2025
Petrosyants K. O., Kharitonov I. A., Силкин Д. С. et al., Наноиндустрия 2024 Т. 17 № S10-1(128) С. 302–312
The paper considers qualitative estimations of CMOS SRAM Cells sensitivity to SEU performed for technological nodes varying from 90 nm up to 28 nm using verified TCAD-SPICE software tools and models. The process and results of simulations have been presented. The estimations of CMOS SRAM cells hardness to SEU have been confirmed using SRAM measurement ...
Added: September 3, 2024
Gazizov R., Gazizov T. R., Gazizov R. R., , in: 2018 Moscow Workshop on Electronic and Networking Technologies (MWENT). Proceedings.: M.: IEEE, 2018. P. 1–4.
The paper highlights the importance of using evolution strategy (ES) in investigating ultrashort pulse peak voltages in multiconductor structures of printed circuit boards (PCB). Trapezoidal ultrashort pulse propagation along the conductors of a real PCB multiconductor bus was simulated and, with ES, the whole ultrashort pulse duration was optimized using the criterion of peak voltage ...
Added: May 17, 2024
Gazizov R., Gazizov R. R., Gazizova E. E., , in: 2019 International Siberian Conference on Control and Communications (SIBCON). Proceedings.: Tomsk: Tomsk State University of Control Systems and Radioelectronics (TUSUR), 2019. P. 1–4.
The simulation of the ultrashort pulse propagation along the conductors of the microstrip C-section has been carried out when the losses in conductors and dielectric were taken into account and without them. The voltage extreme points have been obtained with using of 7 values of the half-turn length. The highest voltage maximum exceeds the amplitude ...
Added: May 17, 2024
Gazizov R., Системы управления, связи и безопасности 2023 Т. 4 С. 267–282
Problem statement: As the number of electronic devices grows, it can become difficult for them to work together. The current trend towards miniaturization motivates developers of electronic equipment to design components so that there is a minimum distance between them. However, small distances produce serious coupling issue for the device operation. More specifically, when electronic ...
Added: December 10, 2023
R. R. Gazizov, Kvasnikov A. A., A. A. Yelizarov, , in: 2023 International Conference on Engineering Management of Communication and Technology (EMCTECH).: IEEE, 2023. P. 1–5.
In this article, we present an improved algorithm that identifies for signal propagation paths in electronic devices in a computer simulation system and compare it with an original algorithm. The novel logic of the algorithm uses all possible signal propagation paths, and as an excitation, we apply ultrashort pulses. To get full data on the ...
Added: November 24, 2023
Poselyagin N., Новое литературное обозрение 2023 Т. 182 № 4 С. 48–60
The article discusses a rhetorical aspect of the newly popular term “post-truth”. I suppose, post-truth can be considered as a practical consequence of a social phenomenon described by Jean Baudrillard. A mediaspace in which we are immersed does not allow us to distinguish between reality and simulation, between an actual event or a real fact ...
Added: September 20, 2023
Karpenko I., Праксема. Проблемы визуальной семиотики 2023 № 3(37) С. 142–158
The most common definitions of virtual reality state it as created artificially (by technical means) and open for interactions with the subject (the one who perceives it) with the help of the sensory organs. That is, this artificially created reality acts for the subject as a certain sign, which is visually accessible and somehow interpreted ...
Added: March 28, 2023
Rustam R. Gazizov, Gazizov R., Gazizov T., , in: 2020 Moscow Workshop on Electronic and Networking Technologies (MWENT).: IEEE, 2020. P. 1–3.
The paper presents the results of preliminary research into the propagation of common-mode excitation of electrostatic discharge along the conductors of the shielded power supply (PS) bus. To investigate signal propagation, we chose nine intervals, and detected and localized signal extreme points for the case when the start signals are located in the end branch conductors ...
Added: December 16, 2022
Rustam R. Gazizov, Gazizov R., Gazizov T., , in: 2020 21st International Conference of Young Specialists on Micro/Nanotechnologies and Electron Devices (EDM).: IEEE, 2020. P. 174–178.
Added: December 16, 2022
Gazizov R., Gazizov R., Gazizov T., , in: 2020 Dynamics of Systems, Mechanisms and Machines (Dynamics).: Omsk: IEEE, 2020. P. 1–4.
The paper presents the circuit diagram and the parameters of the cross-section for the model of the power supply (PS) bus of a spacecraft. The optimization of the duration of an ultrashort pulse (USP) exiting the PS bus was made by genetic algorithm(GA) for minimizing the voltage maximum along the PS bus. The GA optimization ...
Added: December 16, 2022
Rustam R. Gazizov, Gazizov T., , in: Ural Symposium on Biomedical Engineering, Radioelectronics and Information Technology (USBEREIT).: IEEE, 2022. P. 119–121.
The paper describes the effect of humidity and temperature on printed circuit board with a modal reservation and edge-coupling. Step by step, the development of a geometric model of a cross section, the calculation of matrices of primary and secondary parameters, the development of a schematic model, the obtaining simulation models, the development of N-norm ...
Added: December 16, 2022