Modeling the Operation of a Sensor Unit in a Monitoring Device for the Parameters of Cosmic Ray Fluxes
A mathematical model is developed for a multichannel sensor unit based on diamond detectors in a device for monitoring the parameters of cosmic ray fluxes. The output signals from these sensors are modelled as they detect ionizing radiation from outer space in different spacecraft orbits with various levels of solar activity.
Simulation of electron, ion and metastable excited atom motion and interactions in a low-current discharge between the flat electrodes of a gas- discharge device in argon-mercury mixture is fulfilled. Also influence of gas temperature on both densities and fluxes of particles has been investigated. Distributions of the particle densities along the discharge gap under different mixture temperatures are obtained. It has been demonstrated that the principal mechanism of mercury ion generation was the Penning ionization of mercury atoms by argon metastables, which contribution grows sharply with the mixture temperature due to mercury density increase. Calculations showed that both mercury and argon ion flow densities near the cathode where of the same order already under the relative mercury content of about 10-4 corresponding at the argon pressure 103 Pa to the mixture temperature 30 C. Because the mean path length of a mercury ion in the mixture between the resonant charge exchanges on parent gas atoms is much more than that of an argon ion, the energies of mercury ions exceed considerably the energies of argon ions, and they make the main contribution to the physical electrode sputtering. which reduces the service time of the gas- discharge device.
Application of the software for modelling of decoupling condensers in power system circuits of microcircuits is considered. Recommendations about a rational choice of condensers are given.
The fresh surfaces formation provided by materials destruction or cleavage often leads to surfaces charging and strong electric fields generation. These fields can create the high energy electrons beams and Bremsstrahlung radiation. For example the destruction of quartz and granite is accomplished by low intensity relativistic electron fluxes creation. However the adhesive tapes peeling is accomplished by significantly more intensive electron beams creation. These beams can provide hard irradiation of skin and other layers of biological tissues during the adhesive tapes separation. We will estimate this irradiation using the generalized diffusion model for non-relativistic electrons.
The Handbook of CO₂ in Power Systems' objective is to include the state-of-the-art developments that occurred in power systems taking CO₂ emission into account. The book includes power systems operation modeling with CO₂ emissions considerations, CO₂ market mechanism modeling, CO₂ regulation policy modeling, carbon price forecasting, and carbon capture modeling. For each of the subjects, at least one article authored by a world specialist on the specific domain is included.
Conference Paper of 2016 5th Mediterranean Conference on Embedded Computing, MECO 2016 - Including ECyPS 2016, BIOENG.MED 2016, MECO: Student Challenge 2016
This proceedings set contains 85 selected full papers presentedat the 3rd International Conference on Modelling, Computation and Optimization in Information Systems and Management Sciences - MCO 2015, held on May 11–13, 2015 at Lorraine University, France. The present part II of the 2 volume set includes articles devoted to Data analysis and Data mining, Heuristic / Meta heuristic methods for operational research applications, Optimization applied to surveillance and threat detection, Maintenance and Scheduling, Post Crises banking and eco-finance modelling, Transportation, as well as Technologies and methods for multi-stakeholder decision analysis in public settings.
Experiments indicating acceleration of charged particles as a result of separation of solid surfaces are analyzed. As a possible mechanism of such acceleration, generation of surface charge on the separated surfaces of a cleaved ionic crystal is considered. The maximum electric field generated due to the charging of the separated surfaces and the energy of electrons accelerated in such a field are estimated. It is shown that, for the maximum attainable electric field, conditions are created for the generation of runaway electrons that, even at atmospheric pressure, electrons are accelerated to high energies, not experiencing collisions with gas particles.
Generalized error-locating codes are discussed. An algorithm for calculation of the upper bound of the probability of erroneous decoding for known code parameters and the input error probability is given. Based on this algorithm, an algorithm for selection of the code parameters for a specified design and input and output error probabilities is constructed. The lower bound of the probability of erroneous decoding is given. Examples of the dependence of the probability of erroneous decoding on the input error probability are given and the behavior of the obtained curves is explained.
The dynamics of a two-component Davydov-Scott (DS) soliton with a small mismatch of the initial location or velocity of the high-frequency (HF) component was investigated within the framework of the Zakharov-type system of two coupled equations for the HF and low-frequency (LF) fields. In this system, the HF field is described by the linear Schrödinger equation with the potential generated by the LF component varying in time and space. The LF component in this system is described by the Korteweg-de Vries equation with a term of quadratic influence of the HF field on the LF field. The frequency of the DS soliton`s component oscillation was found analytically using the balance equation. The perturbed DS soliton was shown to be stable. The analytical results were confirmed by numerical simulations.
By using superconducting quantum interference device (SQUID) magnetometry, we investigated anisotropic high-field (H less than or similar to 7T) low-temperature (10 K) magnetization response of inhomogeneous nanoisland FeNi films grown by rf sputtering deposition on Sitall (TiO2) glass substrates. In the grown FeNi films, the FeNi layer nominal thickness varied from 0.6 to 2.5 nm, across the percolation transition at the d(c) similar or equal to 1.8 nm. We discovered that, beyond conventional spin-magnetism of Fe21Ni79 permalloy, the extracted out-of-plane magnetization response of the nanoisland FeNi films is not saturated in the range of investigated magnetic fields and exhibits paramagnetic-like behavior. We found that the anomalous out-of-plane magnetization response exhibits an escalating slope with increase in the nominal film thickness from 0.6 to 1.1 nm, however, it decreases with further increase in the film thickness, and then practically vanishes on approaching the FeNi film percolation threshold. At the same time, the in-plane response demonstrates saturation behavior above 1.5-2T, competing with anomalously large diamagnetic-like response, which becomes pronounced at high magnetic fields. It is possible that the supported-metal interaction leads to the creation of a thin charge-transfer (CT) layer and a Schottky barrier at the FeNi film/Sitall (TiO2) interface. Then, in the system with nanoscale circular domains, the observed anomalous paramagnetic-like magnetization response can be associated with a large orbital moment of the localized electrons. In addition, the inhomogeneous nanoisland FeNi films can possess spontaneous ordering of toroidal moments, which can be either of orbital or spin origin. The system with toroidal inhomogeneity can lead to anomalously strong diamagnetic-like response. The observed magnetization response is determined by the interplay between the paramagnetic-and diamagnetic-like contributions.