Электроника, микро- и наноэлектроника. Сборник научных трудов 13-ой Российской научно-технической конференции. Суздаль 2012 г.
AMT 2013 is the most comprehensive conference focused on the various aspects of advances in Advanced Measurement and Test. The conference provides a chance for academic and industry professionals to discuss recent progress in the area of Advanced Measurement and Test. The goal of AMT2013 is to bring together the researchers from academia and industry as well as practitioners to share ideas, problems and solutions relating to the multifaceted aspects of Advanced Measurement and Test.
The monograph presents results by professor Dr. A. Shalumov’s Research School of Modeling, Information Technology and Automated Systems (Russia). The program, ASONIKA, developed by the school is reviewed here regarding reliability and quality of devices for simulation of electronics and chips during harmonic and random vibration, single and multiple impacts, linear acceleration and acoustic noise, and steady-state and transient thermal effects. Calculations are done for thermal stress during changes in temperature and power in time. Calculations are done for number of cycles to fatigue failure under mechanical loads as well as under cyclic thermal effects. Simulation results for reliability analysis are taken into account. Models, software interface, and simulation examples are presented.
For engineers and scientists involved in design automation of electronics.
The CLAS12 experiment is intended to study the generalized parton distributions in exclusive reactions. The CLAS12 Silicon Vertex Tracker must provide the registration of all reaction products at the expected high luminosity. The results of a GEANT4 simulation of the expected physical rates in the SVT are presented. The frequency of the noise hits of the readout electronics is determined on the basis of the capacitive load generated by the attached sensors. In order to find the fraction of the events that are lost due to delays in the readout electronics, a computer simulation of the logic of the data-driven readout FSSR2 chip is performed. At a signal-to-noise ratio of 8 to 1 the readout electronics are capable of processing the expected rates, provided a registration threshold of 0.4 mip is preset.
IX International students’conference: INNOVATIONS IN SCIENCE AND TECHNOLOGY Allowed languages: English, German, French, Spanish. List of the sections possible: 1. Engineering Innovations 2. Modern Information Technologies 3. Electronics 4. Natural Sciences 5. Social Sciences
The project of laboratory practical works for studying of different electronic devices based on microcircuits of operational amplifiers was developed.
Based on the above-described method of the electronic structures synthesis, an automated subsystem ASONIKA-V has been developed. This subsystem is designed to analyze the mechanical characteristics and synthesis of cabinets structures, racks and blocks electronics, mounted on vibration isolators, under the influence of harmonic vibration, random vibration, shock loads, linear acceleration, under the influence of acoustic noise, as well as complex mechanical influences and decision-making on the basis of the mechanical characteristics in order to ensure structures stability of electronic to mechanical stress.
The questions of protecting from the vibrations objects are considered in control-diagnostic and technological equipment. Offered four level system of defence of objects of microelectronics from vibrations. For each of levels of the system the technological decisions of protecting from the vibrations devices are presented
Generalized error-locating codes are discussed. An algorithm for calculation of the upper bound of the probability of erroneous decoding for known code parameters and the input error probability is given. Based on this algorithm, an algorithm for selection of the code parameters for a specified design and input and output error probabilities is constructed. The lower bound of the probability of erroneous decoding is given. Examples of the dependence of the probability of erroneous decoding on the input error probability are given and the behavior of the obtained curves is explained.
The dynamics of a two-component Davydov-Scott (DS) soliton with a small mismatch of the initial location or velocity of the high-frequency (HF) component was investigated within the framework of the Zakharov-type system of two coupled equations for the HF and low-frequency (LF) fields. In this system, the HF field is described by the linear Schrödinger equation with the potential generated by the LF component varying in time and space. The LF component in this system is described by the Korteweg-de Vries equation with a term of quadratic influence of the HF field on the LF field. The frequency of the DS soliton`s component oscillation was found analytically using the balance equation. The perturbed DS soliton was shown to be stable. The analytical results were confirmed by numerical simulations.
The conference “2021 Systems of signals generating and processing in the field of on board communications” is organized with technical sponsorship of Russian (Moscow) IEEE Circuits and Systems (CAS04) Chapter IEEE Region 8, Russian Section Chapter, MTT/ED and Institute of Radio and Information Systems Association (IRIS), Vienna, Austria. The conference featured invited researchers, educators, managers, and graduate students, whose research activity, case studies or best practices, are shedding light on the theory or practice of engineering, include modern digital transportation systems design and technical operation, radio waves propagation, transmitting, receiving and processing signals in television and radio broadcasting devices, information technologies in transport. The main areas of the conference “Systems of signals generating and processing in the field of on board communications” include modern digital transportation systems design and technical operation, radio waves propagation, transmitting, receiving and processing signals in television and radio broadcasting devices, information technologies in transport. FIELD OF INTEREST: Components, Circuits, Devices and Systems; General Topics for Engineers; Signal Processing and Analysis. Reports presented at the conference are grouped in 6 sections: 1. Antennas and Radio Waves Propagation. 2. Navigation and Mathematical Algorithms of an Object Space Orientation. 3. Radiofrequency Applications. 4. Wire and Optical Communication and Control Systems. 5. Intelligent Transport Systems (ITS): Sub-section 1: Use of digital ITS infrastructure in telematic control systems on urban passenger transport Sub-section 2: Peculiarities of data exchange in cooperative ITS Sub-section 3: Theoretical Aspects of Artificial Intelligence Systems Development for Transportation Engineering Sub-section 4: Test methods of motor vehicles integrated into an intelligent transport environment 6. Digital signal processing in on-board radio systems
Radiation conditions are described for various space regions, radiation-induced effects in spacecraft materials and equipment components are considered and information on theoretical, computational, and experimental methods for studying radiation effects are presented. The peculiarities of radiation effects on nanostructures and some problems related to modeling and radiation testing of such structures are considered.
This volume presents new results in the study and optimization of information transmission models in telecommunication networks using different approaches, mainly based on theiries of queueing systems and queueing networks .
The paper provides a number of proposed draft operational guidelines for technology measurement and includes a number of tentative technology definitions to be used for statistical purposes, principles for identification and classification of potentially growing technology areas, suggestions on the survey strategies and indicators. These are the key components of an internationally harmonized framework for collecting and interpreting technology data that would need to be further developed through a broader consultation process. A summary of definitions of technology already available in OECD manuals and the stocktaking results are provided in the Annex section.