Article
Исследование паразитного излучения кромок многослойных печатных плат СВЧ диапазона
Questions of designing of printed-circuit boards for systems of high speed are considered. The basic attention is given maintenance of signal integrity in standard lines TTL/CMOS and in differential pairs. Physical aspects of decrease in level of hindrances in details understand chains of ultrafast devices. Base data on materials for printed-circuit boards, their properties and influence on quality of a signal are resulted. In the book practical recommendations to design designing of PCB electronics are given. The statement is accompanied by the big number of examples and numerical calculations. The stated material has a practical orientation and is focused, first of all, on developers and designers of electronic equipment. The book will be useful to the technical experts, occupied in research, industrial and other spheres of creation of electronic means. It is possible to recommend the edition as the manual to bachelors, masters and post-graduate students of corresponding directions of preparation.
For the first time in the domestic technical literature questions of designing of system of power delivery network (PDN) of electronic modules of electronic equipment are considered. Noise in the power supply system of high-speed digital modules are one of the basic problems without which decision working capacity of modules cannot be guaranteed. These decisions should be based on deep physical understanding of the processes occurring in the power supply system of digital modules, the analysis of sources of noise and methods of their suppression, the account of features of traditional and new componental base and outcomes, and also specificity of topological designing of multilayered printed-circuit boards. In the book the listed questions are in details considered, the scientifically-proved recommendations on design of printing modules of digital equipment are given. The statement is accompanied by the big number of examples and numerical calculations. The stated material has a practical orientation and is focused, first of all, on developers and designers of electronic equipment. The book will be useful to the technical experts occupied in research, industrial and other spheres of creation of electronic means. It is possible to recommend the edition as the manual to bachelors, masters and post-graduate students of corresponding directions of preparation.
Generalized error-locating codes are discussed. An algorithm for calculation of the upper bound of the probability of erroneous decoding for known code parameters and the input error probability is given. Based on this algorithm, an algorithm for selection of the code parameters for a specified design and input and output error probabilities is constructed. The lower bound of the probability of erroneous decoding is given. Examples of the dependence of the probability of erroneous decoding on the input error probability are given and the behavior of the obtained curves is explained.
The dynamics of a two-component Davydov-Scott (DS) soliton with a small mismatch of the initial location or velocity of the high-frequency (HF) component was investigated within the framework of the Zakharov-type system of two coupled equations for the HF and low-frequency (LF) fields. In this system, the HF field is described by the linear Schrödinger equation with the potential generated by the LF component varying in time and space. The LF component in this system is described by the Korteweg-de Vries equation with a term of quadratic influence of the HF field on the LF field. The frequency of the DS soliton`s component oscillation was found analytically using the balance equation. The perturbed DS soliton was shown to be stable. The analytical results were confirmed by numerical simulations.
Radiation conditions are described for various space regions, radiation-induced effects in spacecraft materials and equipment components are considered and information on theoretical, computational, and experimental methods for studying radiation effects are presented. The peculiarities of radiation effects on nanostructures and some problems related to modeling and radiation testing of such structures are considered.
This volume presents new results in the study and optimization of information transmission models in telecommunication networks using different approaches, mainly based on theiries of queueing systems and queueing networks .
The paper provides a number of proposed draft operational guidelines for technology measurement and includes a number of tentative technology definitions to be used for statistical purposes, principles for identification and classification of potentially growing technology areas, suggestions on the survey strategies and indicators. These are the key components of an internationally harmonized framework for collecting and interpreting technology data that would need to be further developed through a broader consultation process. A summary of definitions of technology already available in OECD manuals and the stocktaking results are provided in the Annex section.