Качественный анализ, прогноз и компьютерное моделирование МОП и КМОП наносхемотехники для твердотельных классических суперкомпьютеров
The results concern roll pass design for rolling a round bar of a 20mm diameter from a 55mm diameter input. Concerning materials, this roll pass design must cover a wide range of steels, from low-carbon micro-alloyed steels to stainless steels. The roll pass design proposal takes into consideration lower plasticity of certain steels. The comparison was enabled by suggesting two roll pass designs. The classical oval-round roll pass design, where the maximum extension coefficient is set to 1.55 in oval and 1.22 in round grooves. The second roll pass design uses a combination of smooth part of the roll (curves) and round roll passes. Distribution of the extension coefficient in individual passes is similar to that of oval-round series. The paper also compares values of energy-force parameters calculated analytically using the method of finite elements. If we compare the distribution of temperature, stress and size of the grain, it is proved that the oval-round roll pass designs are the best as far as the balanced distribution of the above-mentioned values is concerned. The roll pas design combining smooth part of the roll with a round part does not achieve such balance. However, its advantage lies in far lower requirement for the needed length of the working part of the roll. Five passes are carried out on the smooth part of the roll, which considerably cuts down the required length of the roll body. Therefore it is this variant that will be used in the laboratory of wire rolling created within the project RMSTC.
This volume presents new results in the study and optimization of information transmission models in telecommunication networks using different approaches, mainly based on theiries of queueing systems and queueing networks .
The paper provides a number of proposed draft operational guidelines for technology measurement and includes a number of tentative technology definitions to be used for statistical purposes, principles for identification and classification of potentially growing technology areas, suggestions on the survey strategies and indicators. These are the key components of an internationally harmonized framework for collecting and interpreting technology data that would need to be further developed through a broader consultation process. A summary of definitions of technology already available in OECD manuals and the stocktaking results are provided in the Annex section.