?
Экспериментальное исследование формы тока ЭСР при разряде с печатной платой
Технологии электромагнитной совместимости. 2014. № 1(48). С. 46-52.
Charged board model (CBM) is considered. CBM is specific case of charged device model ESD event. The case of lowering components CDM rating, reported by other researchers, is considered. ESD current waveform experimaetal measurements and simulations were performed. Experimental and simulation results are in good match
Research target:
Electronics and Electrical Engineering
Priority areas:
engineering science
Language:
Russian
Kuznetsov V., Kechiev L., IEEE Transactions on Electromagnetic Compatibility 2015 Vol. 57 No. 5 P. 947-954
In this paper, power MOS transistor behavior under charged board model (CBM) ESD impact is considered. The analysis of the MOSFET failure condition at the CBM ESD event is performed. The CBM equivalent circuit is proposed. The physical parameters of the PCB and device under test are replaced by the lumped RCL circuit. The MOSFET ...
Added: January 1, 2016
Kechiev L., Kuznetzov V. V., Технологии электромагнитной совместимости 2013 № 1(44) С. 29-38
Проведено моделирование воздействия электростатического разряда на МОП-транзисторы, установленные на печатной плате. Результаты моделирования сравниваются с результатами испытаний тестовой печатной платы на воздействия ЭСР и проводится исследование воздействия печатной платы на порог отказа МОП-транзисторов при воздействии ЭСР по сравнению с их собственным порогом отказа. Обнаружено снижение порога отказа при ЭСР для транзисторов, установленных на печатной плате. ...
Added: May 3, 2013
Kechiev L., Kuznetzov V. V., Abrameshin A. E., Технологии электромагнитной совместимости 2014 № 1(48) С. 46-52
Charged board model (CBM) is considered. CBM is specific case of charged device model ESD event. The case of lowering components CDM rating, reported by other researchers, is considered. ESD current waveform experimaetal measurements and simulations were performed. Experimental and simulation results are in good match. ...
Added: June 6, 2014
Попов П. О., Shalumov A. S., Чан С. Т. et al., Динамика сложных систем 2013 № 1 С. 42-45
In article the basic approaches to the organisation of modelling of physical processes of radio-electronic means within the limits of virtual design office are considered. ...
Added: October 13, 2013
P. : Atlantis Press, 2015
Added: February 20, 2016
Шалумов М. А., Shalumov A. S., Шалумова Н. А. et al., Автоматизация. Cовременные технологии 2017 Т. 71 № 4 С. 162-166
Рассмотрены вопросы автоматизации моделирования тепловых процессов печатных узлов радиоэлектронных средств с использованием радиаторов в автоматизированной подсистеме анализа конструкций печатных узлов радиоэлектронных средств на тепловые и механические воздействия АСОНИКА-ТМ. ...
Added: October 13, 2017
Zhadnov V. V., Технологии электромагнитной совместимости 2016 № 4 С. 49-52
The considered model of the failure rate of CMOS VHSIC design proposed in the article Piskun G.A., Alekseev V.F., "Improvement of mathematical models calculating of CMOS VLSIC taking into account features of impact of electrostatic discharge", published in the first issue of the journal "Technologies of electromagnetic compatibility" for the year 2016. It is shown ...
Added: October 29, 2016
Kofanov Y. N., М. : Энергоатомиздат, 2014
В данной монографии изложены основы менеджмента качества и надёжности радиоэлектронных средств (РЭС), соответствующие требованиям международных стандартов ИСО серии 9000. Рассмотрены требования современных информационных технологий моделирования к системам менеджмента качества и надёжности РЭС. Показана необходимость введения комплексного менеджмента, обусловленного появлением новой информации в результате комплексного моделирования взаимосвязанных физических процессов в РЭС. Новая информация позволяет создавать РЭС ...
Added: March 29, 2015
Vostrikov A. V., Abrameshin A. E., Технологии электромагнитной совместимости 2012 № 3 С. 22-28
В работе рассмотрены подходы к построению вычислительной схемы ускоренного метода расчета наводок в бортовой кабельной сети космических аппаратов. Показано, что в случае больших эквивалентных электрических схем космических аппаратов для построения вычислительной схемы необходимо решать систему линейных алгебраических уравнений с разреженной блочной матрицей высокого порядка. Учитывая данную специфику, было предложено преобразовать эту матрицу к треугольному виду ...
Added: September 21, 2012
Kechiev L., Шатов Д. С., Технологии электромагнитной совместимости 2014 № 3(50) С. 36-44
In article features of designing of the distributed power supply system are considered, modelling of untying condensers as a part of distributed to the power supply system is spent, the approach to construction of the distributed power supply system is described ...
Added: October 1, 2014
Kaperko A., Nedosekin P., Датчики и системы 2020 № 6 С. 45-51
In this work, a study of a coaxial diamond sensor for registration of protons and electrons is carried out. The process of interaction of charged particles in the volume of the sensor is simulated in the energy range: from 25 MeV to 200 MeV for protons and from 300 keV to 5 MeV for electrons. ...
Added: June 22, 2021
Manohin A., Шалумова Н. А., Чабриков С. В. et al., Наукоемкие технологии 2011 Т. 12 № 11 С. 44-53
In the article are esteemed assigning and main capabilities of the subsystem of the analysis and maintenance of thermal values of designs of radio electronic means ASONIKA-T, and also principles of simulation of thermal processes in designs with the help of the subsystem ASONIKA-T. The example of simulation of thermal processes in a standard design is ...
Added: January 31, 2013
Artyukhova M. A., Polesskiy S., Linetskiy B. et al., Reliability: Theory & Applications 2016 No. 4 P. 84-95
The paper considers the technique of modeling of electronic reliability based on modeling electrical components environment temperature. As experience of the simulation and exploitation of electronic shows, one of the main factors that significantly affect the reliability characteristics is the thermal effect. This is confirmed by the statistics of a number of companies. In the ...
Added: February 28, 2017
D. A. Abrameshin,, E. D. Pozhidaev,, V. S. Saenko et al., IEEE Transactions on Plasma Science 2019 Vol. 47 No. 8 P. 3653-3657
Abstract—We have performed computer simulations and experimental studies of characteristics of a standard analog device—the heterodyne employing a printed circuit board (PCB) made from a composite dielectric with a controlled dark conductivity. Simulation results show that an increased conductivity of the PCB smaller than 2 × 10^−7 Ohm^−1 · m^−1 has almost no effect on the ...
Added: May 27, 2019
Zhadnov V. V., Мир измерений 2016 № 4 С. 8-11
В статье рассматриваются вопросы оценки надёжности электронных измерительных приборов при проектировании. Приводится описание моделей интенсивностей отказов КМОП ИС, учитывающих влияние ЭСР, и показано, что для электронных измерительных приборов, содержащих относительно небольшое количество таких микросхем, применение стандартизованной модели интенсивностей отказов, учитывающей влияние ЭСР, может привести к существенным погрешностям в расчётах надёжности. В качестве альтернативы предложена модель, ...
Added: October 13, 2016
Лемешко Н. В., М. : МИЭМ, 2012
В учебном пособии рассмотрены основы проектирования элементов топологии тонкопленочных гибридных интегральных микросхем. Освещены вопросы расчета пассивных элементов ГИС, принципы проектирования топологии, даны справочные материалы, необходимые для топологического и конструкторского проектирования ГИС. ...
Added: November 29, 2012
Запорожье : ЗМИ, 1992
Added: April 5, 2014
Abrameshin A. E., Zhadnov V. V., Технологии электромагнитной совместимости 2014 № 2 С. 27-34
Indicators of non-failure operation of the onboard space equipment substantially depend on characteristics of reliability microcircuits. One of possible causes of failures microcircuits is influence of catastrophic electrical overstress owing to electrostatic discharges. In article the method of formation of mathematical model of failure rate microcircuits and possibility of its application for microcircuits for the ...
Added: June 10, 2014
Novikov L., Хасаншин Р. Х., Гаценко Л. С. et al., Перспективные материалы 2015 № 1 С. 22-29
A comparative analysis of electrostatic discharges on surfaces of К-208 and CMG glasses under irradiation by 10- to 40-keV electrons with flux densities from 1010 to 2,5×1011 cm-2s-1 in vacuum was done. The discharges accompanied by plasma ejections into surrounding and formation of microprotrusions and discharge channels were observed on the both glasses. However, the ...
Added: August 30, 2015
Polesskiy S., Artyukhova M. A., Reliability: Theory & Applications 2012 Vol. 7 No. 4 P. 90-101
The paper describes the calculation method of reliability and conservability products class of chemical current sources (CCS) in the design to the specific conditions in the electronic means. The technical specification for the indicators of CCS reliability are for specific operation modes and their use in the calculation gives a large error. In the U.S. ...
Added: February 7, 2013
Shalumov A. S., Чабриков С. В., Шалумова Н. А., Динамика сложных систем 2012 Т. 6 № 2 С. 103-108
In article possibilities of a subsystem of the analysis and maintenance of thermal characteristics of designs of radio-electronic means ASONIKA on construction of thermal models at which there is a heat exchange by radiation are considered. Subsystem possibilities on construction of thermal models of designs of the radio-electronic means containing radiators of cooling of semi-conductor ...
Added: November 26, 2012
Bondarenko G., Fisher M. R., Kristya V. I., Journal of Physics: Conference Series 2012 Vol. 406 No. 012031 P. 1-6
Simulation of electron, ion and metastable excited atom motion and interactions in a low-current discharge between the flat electrodes of a gas- discharge device in argon-mercury mixture is fulfilled. Also influence of gas temperature on both densities and fluxes of particles has been investigated. Distributions of the particle densities along the discharge gap under different ...
Added: January 17, 2013
Borisov N., Vostrikov A. V., Krasivskaya M. et al., Технологии электромагнитной совместимости 2014 № 2(49) С. 39-46
The authors developed new reduced computational schemes for the numerical integration of systems of linear differential equations on the basis of methods of Euler. Thus not subjected to the reduction of the original model in the form of a system of linear ordinary differential equations, and mathematical expressions that determine the explicit and implicit methods ...
Added: June 10, 2014
Феськов Д. О., Романов О. Ю., Короткий Є. В., Проблеми iформатизацii та управлiння 2013 No. 2 (42) P. 118-123
The review of different approaches to the simulation of the networks-on-chip (NoC) is performed. The simulator of the NoC where the topology is set with the matrix of connections between the routers that manage the traffic by means of the routing tables is developed. The capabilities of the NoC simulator are examined and the results ...
Added: February 18, 2015