?
Экспериментальные исследования газопроницаемости тонкостенных герметизирующих элементов вакуумных устройств с бесконтактным магнитным взаимодействием
С. 217–220.
Кузнецов П. С., Stepanchikov S. V.
In book
Ч. 2. , М.: МГТУ МИРЭА – ИРЭ РАН, 2013.
Ostovari Moghaddam A., Shaburova N., Naseri M. et al., Metals 2023 Vol. 13 No. 11 Article 1807
Ni-based composite coatings reinforced by high-entropy intermetallic compounds (HEICs) were prepared by detonation spraying (DS) on low alloy steel substrates. To this end, first (Ti-Nb)(V-Cr-Ni-Fe) and Al3(TiZrNbCrHfTa) HEIC powders were fabricated by arc melting followed by ball milling. The as-milled HEIC powders were then employed as reinforcement particles to prepare Ni-7wt.% HEIC composite coatings. The ...
Added: February 18, 2025
Ostovari Moghaddam A., Mikhailov D., Shaburova N. et al., Colloids and Surfaces A: Physicochemical and Engineering Aspects 2025 Vol. 710 Article 136291
In this work, (Fe20Co23.9Ni20Cr15)(Al20Ti1.1) and [(Fe20Co23.9Ni20Cr15)(Al20Ti1.1)]98.5B1.5 chemically complex intermetallic alloys (CCIMAs) were first prepared by vacuum melting followed by ball milling, and then employed as precursor powders for depositing coatings on a low alloy steel substrate using detonation spraying. The precursor CCIMAs exhibited a dense lamellar dual-phase microstructure consisting of multicomponent L12 and Cr-rich BCC ...
Added: February 8, 2025
Ostovari Moghaddam A., Shaburova N., Pashkeev K. et al., Transactions of the Indian Institute of Metals 2025 Vol. 78 Article 61
In this study, BaFe12O19 and three corresponding BaFe6(AlCrTiGaCo)6O19, BaFe2(AlCrTiGaCo)10O19 and BaFe6(AlCrSnGaCo)6O19 high-entropy oxides (HEOs) particles were utilized as reinforcement particles to fabricate Al-matrix composites coatings using cold gas dynamic spraying technique. First, BaFe12O19 and HEOs reinforcement particles with a single BaFe12O19-type structure were fabricated by solid-phase sintering and ball milling. Then, Al-matrix composites with a ...
Added: February 8, 2025
Ahmad Ostovari Moghaddam, Sudarikov M., Shaburova N. et al., Metals 2024 Vol. 14 No. 1 Article 50
This study aims at investigating the feasibility of depositing quality coatings from various high-entropy intermetallic compounds (HEICs) using detonation spraying (DS). Four different HEIC coatings, namely (NbTaVCrTi)Al3, (NbTaVNiFe)Al3, (NbTaVZrHf)Al3, and (FeNiCoCrMn)(MoCr), were prepared by DS on low alloy steel substrates. The HEIC powders were first prepared by arc melting followed by ball milling and then ...
Added: January 23, 2025
Ahmad Ostovari Moghaddam, Shaburova N., Zhivulin D. et al., Journal of Alloys and Compounds 2025 Vol. 1010 Article 177238
Cold gas dynamic spraying was attempted as a new technique to additively fabricate functionally graded Cu-matrix composites reinforced by BaFe12O19 and its corresponding BaFe6(AlCrTiGaCo)6O19, BaFe2(AlCrTiGaCo)10O19 and BaFe6(AlCrSnGaCo)6O19 high entropy oxides (HEOs) particles. The BaFe12O19 and HEOs reinforcement particles, prepared by solid-phase sintering and ball milling, exhibited a single BaFe12O19-type structure and homogenous microstructure. Cu-matrix composites with a gradient lamellar ...
Added: December 29, 2024
Vinogradov A., Dyachkova I. G., Mamontov A. V. et al., Кристаллография 2020 Т. 65 № 6 С. 960–965
The influence of doping with vanadium on the mechanical properties of nanocomposite films deposited on silicon substrates has been investigated. It is found that the material tested is more likely brittle rather than plastic and that the hardness and elastic modulus of an undoped film are somewhat higher than those of vanadium-doped ones. With an ...
Added: September 23, 2020
Колокольцев В. Н., Боровицкая И. В., Парамонова В. В. et al., В кн.: Материалы XI Международной конференции "Взаимодействие излучений с твердым телом" (Минск, Беларусь, 23-25 сентября 2015 г.).: Мн.: Издательский центр БГУ, 2015. С. 308–311.
The paper explored the possibility of obtaining coatings in the interior cavity of thin Cu tubes on the plasma focus devices. A special feature of such devices is the generation of thin plasma jets of high power. It has been shown the fundamental possibility of receiving protective coating in tubes (Cu) due to the erosion ...
Added: October 6, 2015
Ivashov E., Кузнецов П. С., Stepanchikov S. V., В кн.: INTERMATIC - 2011. Материалы Международной научно-технической конференции «Фундаментальные проблемы радиоэлектронного приборостроения», 14-17 ноября 2011 г., МоскваЧ. 4.: М.: МГТУ МИРЭА – ИРЭ РАН, 2011. С. 237–238.
Проводится анализ устройств с бесконтактным магнитным взаимодействием (УБМВ) вакуумного оборудования электронной техники, с точки зрения надёжности шарикоподшипников, работающих в условиях прогреваемого вакуума в диапазоне остаточных давлений 101…10-8 Па и температуры до 500оС. ...
Added: February 8, 2013
Ivashov E., Кузнецов П. С., Stepanchikov S. V., В кн.: INTERMATIC - 2011. Материалы Международной научно-технической конференции «Фундаментальные проблемы радиоэлектронного приборостроения», 14-17 ноября 2011 г., МоскваЧ. 4.: М.: МГТУ МИРЭА – ИРЭ РАН, 2011. С. 219–221.
В работе исследуются перспективные механические системы с бесконтактным магнитным взаимодействием для вакуумного оборудования электронного производства на предмет их газовыделения. Проводится компьютерное моделирование и рассчитывается газовый поток из опорного узла УБМВ, при различных значениях температуры и давления в вакуумной камере. ...
Added: February 8, 2013
Ivashov E., Кузнецов П. С., Stepanchikov S. V., В кн.: Фундаментальные проблемы радиоэлектронного приборостроения. Материалы Международной научно-технической конференции «INTERMATIC – 2012», 3–7 декабря 2012 г., МоскваЧ. 3: Материалы и технологии.: М.: МГТУ МИРЭА – ИРЭ РАН, 2012. С. 134–136.
В работе исследуются перспективные механические системы с бесконтактным магнитным взаимодействием для вакуумного оборудования электронного производства на предмет их газовыделения и влияния на остаточное давление вблизи зоны трения. ...
Added: February 5, 2013