?
Моделирование нагрева катода с тонкой диэлектрической пленкой в тлеющем разряде
С. 159–164.
In book
ФГБНУ "НИИ ПМТ", 2021.
Г. Г. Бондаренко, Кристя В. И., Савичкин Д. О. et al., Поверхность. Рентгеновские, синхротронные и нейтронные исследования 2026 № 4 С. 29–36
Сформулирована модель тлеющего газового разряда в смеси аргона и паров ртути при наличии
на поверхности катода тонкой диэлектрической пленки. Рассчитаны зависимости характеристик
разряда от температуры в интервале ее изменения, в котором заметный вклад в ионизацию
рабочей газовой смеси дает ионизация атомов ртути метастабильными возбужденными атомами
аргона (реакция Пеннинга). Показано, что в случае катода без диэлектрической пленки при
повышении температуры до ...
Added: June 20, 2026
Zheltukhin V. S., Kiselev G. B., A. Yu. Shemakhin et al., High Energy Chemistry 2025 Vol. 59 No. 2 P. 207–214
A non-invasive voltage standing wave ratio (VSWR) method for electron density measurement in
the surface layer of mercury plasma glow discharge is studied. The method is based on determination of resonant frequencies between the plasma layer and the radio frequency signal by the unit standing wave ratio
(SWR) combined with the calculation of the dielectric permittivity and ...
Added: February 25, 2026
Schmitz A., Hanstein L., Klein M. et al., Microgravity Science and Technology 2025 Vol. 37 Article 7
In this work we present an experiment in which we injected microspheres at low pressure into a capacitively coupled argon plasma chamber. The setup was located in the top point of the Einstein-Elevator drop tower in Hannover, Germany, where the microparticles reached their equilibrium position above the lower electrode during 1 g. During the fall, ...
Added: February 25, 2026
Bondarenko G., Fisher M. R., Kristya V. I., Journal of Surface Investigation: X-Ray, Synchrotron and Neutron Techniques 2025 Vol. 19 No. 1 P. 66–72
A model of a cathode layer in a gas glow discharge is formulated taking into account the presence
of a dielectric film with varying thickness on the cathode across different areas of its surface, and in some
areas, the film may be absent. The model includes ion–electron emission from the cathode surface, thermalfield
electron emission from the cathode ...
Added: June 11, 2025
Li L., Li Z., Meng J. et al., Chemical Communications 2025 Vol. 61 No. 45 P. 8252–8255
Sodium-ion batteries (SIBs) have emerged as a promising alternative to lithium-ion batteries due to the abundance and cost-effectiveness of sodium resources. However, their widespread application is hindered by challenges such as sluggish ion diffusion kinetics and structural instability of cathode materials during prolonged cycling. The design of advanced cathode architectures with enhanced ion transport and ...
Added: May 8, 2025
Bondarenko G., Фишер М. Р., Кристя В. И., Поверхность. Рентгеновские, синхротронные и нейтронные исследования 2025 № 1 С. 78–85
Представлена модель катодного слоя тлеющего газового разряда при наличии на катоде
диэлектрической пленки, толщина которой различна на разных участках его поверхности, причем
на части поверхности она может отсутствовать. Модель учитывает ионно-электронную эмиссию
с поверхности катода, термополевую электронную эмиссию из подложки катода в пленку
и термическую электронную эмиссию с участков катода без пленки. Показано, что при нагреве
катода эмиссионная эффективность пленки, ...
Added: May 6, 2025
Г. Г. Бондаренко, Фишер М. Р., Кристя В. И., Известия РАН. Серия физическая 2024 Т. 88 № 4 С. 549–554
Предложена модель катодного слоя тлеющего газового разряда при наличии на катоде диэлектрической оксидной пленки, толщина которой имеет различные значения на разных участках
его поверхности. Изучено влияние неравномерности толщины пленки на эффективный коэффициент электронной эмиссии катода и на характеристики разряда. ...
Added: December 13, 2024
Bondarenko G., Кристя В. И., Савичкин Д. О. et al., Поверхность. Рентгеновские, синхротронные и нейтронные исследования 2024 № 3 С. 81–87
Предложена модель слаботочного газового разряда в смеси аргона и паров ртути при наличии
на поверхности катода тонкой диэлектрической пленки. Модель учитывает, что в такой смеси
существенный вклад в ионизацию рабочего газа может давать ионизация атомов ртути при их
столкновениях с метастабильными возбужденными атомами аргона. В разряде на поверхности
пленки накапливаются положительные заряды, создающие в диэлектрике электрическое поле,
достаточное для возникновения ...
Added: June 12, 2024
G. G. Bondarenko, Kristya V. I., Savichkin D. O. et al., Journal of Surface Investigation: X-Ray, Synchrotron and Neutron Techniques 2024 Vol. 18 No. 2 P. 327–332
We propose a model for a low-current gas discharge in a mixture of argon and mercury vapor in the
presence of a thin dielectric film on the surface of a cathode. The model takes into account that in such a mixture,
a significant contribution to ionization of the working gas can be made by the ionization of ...
Added: April 25, 2024
G. G. Bondarenko, Fisher M. R., Kristya V. I., Bulletin of the Russian Academy of Sciences: Physics 2024 Vol. 88 No. 4 P. 464–468
A model is proposed for describing a cathode layer of a glow gas discharge in the presence on a
cathode of a dielectric oxide film, the thickness of which has different values on different sections of its surface.
The influence is studied of the non-uniformity of the film thickness on the effective coefficient of the
ion-electron emission as ...
Added: April 15, 2024
Dobrovol’skii Y. O., Lyskov N., Mazo G. N., Russian Journal of Electrochemistry 2023 Vol. 59 No. 12 P. 1080–1091
The studies of how the method of organization of the microstructure of Pr2CuO4-based (РСО) cathodes affects the electrochemical characteristics of model electrolyte-supported solid-oxide fuel cells (SOFCs) are carried out. It is shown that the higher thickness of the PCO cathode layer and the introduction of a pore-forming agent increase the specific power of tested SOFCs ...
Added: November 3, 2023
Добровольский Ю. О., Lyskov N., Мазо Г. Н., Электрохимия 2023 Т. 59 № 12 С. 843–855
The influence of the method of organising the cathode microstructure based on Pr2CuO4 (PCO) on the electrochemical characteristics of a model electrolyte-supported solid oxide fuel cell (SOFC) has been investigated. It is shown that an increase in the thickness of the PCO cathode layer and the introduction of a pore-forming agent contribute to an increase ...
Added: October 16, 2023