Physicochemical Properties of Biocoal Obtained by the Mild Pyrolysis of Peat
The effect of mild pyrolysis methods (hydrothermal carbonization and torrefaction) on the physi-cochemical properties of biocoal was studied. It was established that biocoal obtained by hydrothermal car-bonization has a large specific surface area and exerts an exothermic effect upon decomposition; as comparedwith the samples obtained by torrefaction, it has a more dispersed structure and lower ash content.
This article presents a detailed analysis of the economic efficiency of peat utilization for generating electricity and heat in Russian rural areas and decentralized power consumption areas on the basis of the comparison of power tariffs (prices) and full costs of peat-based electricity and heat production. The research was performed using the model-information complex detailed with respect to municipal areas and major peat deposits that was developed at the Energy Institute, National Research University Higher School of Economics. It is shown that the firing of lignin helium fuel (LHF) granules that are made from peat extracted by the excavating method according to the new, patented technology is considered most efficient. In nongasified areas, the total cost of heat power that is generated in new boiler houses on the basis of LHF granules is often lower than the total heat cost for the gasification of the area and construction of gas boiler houses. In some cases, the heat cost in gasified areas is lower when using a boiler house based on LHF granules than that provided by the conversion of a boiler house to gas fuel. It is also shown that the construction of peat-based heat sources with the overall power of up to 27600 GJ/h that generate a heat power of up to 167.5 million GJ/year will be economically efficient in the coming years, provided that the tariffs for energy sources remain the same. Taking into account the supportive measures that were accepted on a legislative basis in July 2016, sources with the total power of up to 70 GW may be effective for peat-based plants with combined heat-andpower generation. To stimulate the utilization of peat in decentralized power consumption areas and rural areas located in the vicinity of deposits of this fuel type, it is also suggested to make amendments in the normative legal base.
The application of mathematical modeling methods (with subsequent computer sales) to determine the parameters of accuracy geometry bands obtained with the new equipment and process the step deformation bands of hard alloys based on copper